Power Bar Set - 7pc
7pc Flex Handle Breaker Bar Set
6in.1/4in.Dr | 10in. 3/4in.Dr | 15in.1/2in.Dr
Plus 3in. and 6in. Extension Bars
and 3/8 to 1/2in.Dr | 1/2 to 3/4in.Dr Adaptors
with Swivel Heads 180 degree range of motion.
Delivers torque at multiple angles for maximum reach and efficiency.
Crankshaft Timing Case Remover - BMW
BMW Front Crankshaft Timing Case Cover Remover / Installer
For correcting alignment of the front crankshaft timing case cover / at bottom
also helps prevent damage to the new seal during fitting.
Applicable to : BMW 1 | 2 | 3 | 4 Series - X1 | X2
Mini Clubman / Hatch / Countryman.
Crankshaft Seal Flange Installation Tool
Crankshaft Oil Seal Tool for VW
The flywheel end oil seal is integral with the oil seal housing
and speed sender and is supplied with a new timing ring.
If the oil seal is faulty then the whole assembly must be renewed.
Suitable for VW Crafter 2.5L / 2006 - 2013
2.5L TDI engine codes : BJJ | BJK | BJL | BJM
2.5L Blue TDI engine codes : CEBA | CEBB | CECA | CECB
OEM : T50010
Transmission Oil Pump
Transmission Oil Hand Pump
7L Reservoir with 15 Adaptors
Suitable for Manual and Automatic Transmissions.
Viscosity range : SAE0 to SAE140
Capacity : 80cc per cycle
Includes 15 adaptors for :
BMW / Ford / Honda / Hyundai / Kia / Mercedes / Mini / Nissan / Toyota / VAG / Volvo Vehicles
Wheel Bearing Tool Set - VAG
18pc Silent Bearing Tool Set for VAG Rear Axles
For assembly and disassembly of bearings both on and off the vehicle.
For the replacement of silent bearings from the wheel bearing housing
axle guide / trailing arm / wishbone lower / internal as built in
push rod and the upper wishbone not built-in.
For use alongside mechanical spindle.
Applicable to most Audi / VW / Seat vehicles
Air Compressor - Portable
Portable Air Compressor
with Tyre Inflation Gauge and Attachments
Voltage : 230V / 50Hz
Rated output power : 1100W
Operating mode type : S3 15 percent
Compressor speed : 3550rpm
Theoretical suction power : 180 L/min
Max. working pressure : 8 bar
Protection class : II / IP20
Hydraulic Press Accessory Kit
6pc Hydraulic Press Accessory Kit
For use with up to 50 Ton press
Constructed from high quality material to ensure long lasting durable performance.
Kit Includes :
3 x Punches : 1/2 | 1 | 1-7/8in.
2 x Steel press plates : 14 x 3 x1in.
1 x Bearing shield
Can be used in a variety of press applications.
Nibbler - 230V / 380W
230V / 380W / 50hz
No load speed : 1800/min
Cutting thickness - Sheet Steel : 0.5 - 1.8mm | Stainless Steel : 0.5 - 1.2mm
Cuts metal under 1.8mm thick in any direction and to any shape -
Leaving smooth cutting surface with no burrs.
Cutter may be ground to restore cutting efficiency.